Question:

What does each diagnostic code mean and what should be done to fix the issue?

Answer:

Diagnostic codes covered (in alphabetical order):

"_ _": Indicates an EEPROM fault; replace the main PCB (DC92-00133A).

2E: Voltage for motor control bus is over/under specified limit; replace the main PCB (DC92-00133A).

3E: No response from Hall Effect Sensor; try resetting, if not working, service needed; Drum Motor (DC31-00049A).

8E: Replace MEMS Sensor (MFS-MEMS-00).

dC: Imbalance detected during spin cycle; level the machine, secure leg lock nuts; Drum Motor (DC96-01218D), older models use MEMS Sensor (MFS-MEMS-00).

E2: Jammed input key on control panel; replace Display Panel (DC97-12609B).

FL: Door lock fails to unlock after 3 attempts; check door latch's strike plate, misalignment; replace Door Lock Assembly (DC64-00519B).

Hr: Reset the washer, if same code returns, replace Main PCB (MFS-WF318A-TO).

LE: Problem with Water Level Sensor; check for suds, use only HE detergent, recommended amount; if no suds, service required.

LO: Same as FL; replace Door Lock Assembly (DC64-00519B).

nd: Water level failed to drop within 15 mins; check drain hose, remove restrictions; if not working, replace Drain Pump (DC96-01585A).

nF: Filling continues >16 mins, no change in water level; check supply valves, clean debris screens, try hot/cold water; replace Hot Water Valve (DC62-30314K), Cold Water Valve (DC62-00142G), or Water Level Sensor (DC97-0316C) accordingly.

OE: Fault detected in Water Level Sensor; reset unit, if error code returns, service required; Water Level Sensor (DC97-0316C).

PF: Power interruption during wash cycle; no action needed.

Sr: System relay failure; replace Main PCB (MFS-WF318A-TO).