Note: Menus and illustrations may not exactly match your TV.

1. Connect an antenna or direct RF (Coax) cable line to the input on the back of the TV.

2. With the TV on, press MENU on your remote to bring up the Main Menu. Then, press ▼ to the Channel Menu, and then press ENTER.

Important: If the Channel Menu is greyed out, you must exit the menu and then press the TV button on your remote.



Note: The sub menu's name will be displayed on the left side of the menu.

Press the ▼ to select Auto Program, and then press ENTER.

4. Use the ▲ or ▼ arrow to highlight either Air or Cable, and then press ENTER. If you selected Air, continue to Step 7. If you selected Cable, continue to Step 5.

5. Use the ▲ or ▼ arrow to highlight STD, HRC, or IRC, and then press ENTER. Repeat for digital channels.

Note: The most common cable system is STD, however some smaller cable companies still use the older HRC or IRC systems. Your cable company transmits digital and analog on the same cable system. 

6. Press ENTER once more on Start to begin programming channels into the TV.

7. The TV memorizes all stations first and then removes scrambled channels. This process can take over 20 minutes.
   

 

8. When the Auto Program is complete, press ENTER to begin watching TV.

 

If You Still Need Help?

If you are still having a problem after following the steps above, please contact us for further support. When an agent is available, you can click the “Live Help – Start Chat” button below and begin chatting with a live technical support agent. You can also click the “Phone Support” button, fill out a service request with the details of this session, and then call in and speak to a technical support agent.