Home > Setup & Installation ► > Connections ► > How To Connect A Cable Or Satellite Box (Set-Top-Box) > Connect A Standard Definition Set-Top-Box > Connect An SD Box To Your TV With A Coaxial (RF) Cable
Connect An SD Box To Your TV With A Coaxial (RF) Cable
Cyber

Question:

How to connect an SD box to your TV using a coaxial (RF) cable?

 

Answer:

To connect an SD box to your TV using a coaxial (RF) cable, follow these steps:

  1. Connect one end of the coaxial (RF) cable to the OUT on you SD box.
  2. Connect the other end of the coaxial (RF) cable to ANT IN on your TV.

  1. Turn your TV on, and (using the Samsung TV remote control) press the SOURCE button on your remote control until you have selected the TV input.

    2. Important: If you are using a SATELLITE SD Box, you may have to set the signal source on the TV to Air instead Cable. For instructions on how to select Air as the signal source, click here to view Switching Your Antenna Between Air And Cable in this guide.

  1. Using the TVs remote, set the TV to the RF Output Channel designated by your satellite or cable company. In most areas of the country the RF channel is either channel 3 or channel 4.

    2. Note: If you are still having problems getting your equipment to work properly, click here to go to our advanced connection guide Wire Wizard.

 
 

Please contact our technical support team so that we can further troubleshoot your product over the phone and determine if service is needed. Click the phone support button below to receive a transaction number which will provide the technical support agent with the details of this session.


Was this article helpful?
 Yes  Somewhat  No
If none of the articles addressed your problem, please take a few minutes to describe the problem below.